This very long video is just me talking you through the process of opening the Genesis Coupe Headlights. I explain how to open the headlights safely and quickly, the best areas to focus on, as well as the tricks I've learned to remove the clear lens and shroud from the main bezel (housing).
Whether you want to install angel eyes, custom paint your headlights, or even install clear corner reflectors, this is the video to watch to help you get there!
Start out by removing the two 10mm bolts on your headlights, and then removing the plastic philips head plug on the bumper, near the inside corner of the headlights. Pull up gently on the bumper to allow it to move outward, and pop out the inside corner of the headlight out first, then the outer. There is a zip tie holding the headlight to the main harness that plugs into the back of the light, and the HID headlights have a plug to the auto adjust motor as well.
Pull the lights off (takes just a few minutes), and preheat your oven to 250º and this video will explain the rest!
Join the Community on Discord
https://discord.gg/NxDQU78
FOLLOW US ON SOCIAL MEDIA
IG: http://www.instagram.com/FlyRyde
FB: http://www.facebook.com/FlyRyde
Twitter: http://www.twitter.com/FlyRyde
Whether you want to install angel eyes, custom paint your headlights, or even install clear corner reflectors, this is the video to watch to help you get there!
Start out by removing the two 10mm bolts on your headlights, and then removing the plastic philips head plug on the bumper, near the inside corner of the headlights. Pull up gently on the bumper to allow it to move outward, and pop out the inside corner of the headlight out first, then the outer. There is a zip tie holding the headlight to the main harness that plugs into the back of the light, and the HID headlights have a plug to the auto adjust motor as well.
Pull the lights off (takes just a few minutes), and preheat your oven to 250º and this video will explain the rest!
Join the Community on Discord
https://discord.gg/NxDQU78
FOLLOW US ON SOCIAL MEDIA
IG: http://www.instagram.com/FlyRyde
FB: http://www.facebook.com/FlyRyde
Twitter: http://www.twitter.com/FlyRyde
Question do you take the ballast out?
Wow using a screwdriver? 250 degrees what were you thanking? Not as bad as me doing my first build in the back of the sprinter using the heat gun to heat it up and like I said before trying to ory it open o went to work on it like there was a million dollars inside and. I only had a minute to get to it. And it still took 12 hours. You ever go back and watch your old videos?
The old silicon is going to be a bitch to remove, I assume? Since it'll need nice new fresh stuff once we put it all back together!?
opening them up shortly and following your video for instructions! wish me luck!
Where can i buy the headlights used in the video? I dont see them on your site.
If I wanted to put an extra hid projector for the high beam what size would I use and Halo rings for both
What did you use to seal them back together
anyone have a spare driver's side inner turn signal lens?
Do I have to remove the ballast to do this process? Thanks a lot!!
Can I do it without the silicon sheet?
Tried doing this and it’s nearly impossible to get the lens off of mine
What year gen coupe is this for?
Can you leave the wires in when you bake them?
The camera quality sucks ass!
Wtf? I can't even see what your doing!?
Thank you for making this video! It really helped with figuring out how take all of the pieces apart!