Almost nobody out there has really seen the process of custom building sequential LED lights. You may have seen the end result floating around Instagram and Facebook, but the process of going from stock lights to fully modified wiring, isn't really something you'll find a guide, or a kit to help you with.
If I were to break this down into steps, it'd look like this:
1. Open the lights
2. Trace down all power and ground wires for each LED
3. Strip, solder and heatshrink all ground wires, each with its own resistor
4. Connect all power wires together
5. Solder ribbon cable with connector for Ghozt sequencers
6. Reassemble and Reseal the Lights
7. Build Wire Harness to power Ghozt
Join the Community on Discord
https://discord.gg/NxDQU78
FOLLOW US ON SOCIAL MEDIA
IG: http://www.instagram.com/FlyRyde
FB: http://www.facebook.com/FlyRyde
Twitter: http://www.twitter.com/FlyRyde
If I were to break this down into steps, it'd look like this:
1. Open the lights
2. Trace down all power and ground wires for each LED
3. Strip, solder and heatshrink all ground wires, each with its own resistor
4. Connect all power wires together
5. Solder ribbon cable with connector for Ghozt sequencers
6. Reassemble and Reseal the Lights
7. Build Wire Harness to power Ghozt
Join the Community on Discord
https://discord.gg/NxDQU78
FOLLOW US ON SOCIAL MEDIA
IG: http://www.instagram.com/FlyRyde
FB: http://www.facebook.com/FlyRyde
Twitter: http://www.twitter.com/FlyRyde
Yo I enjoyed watching all your videos.
I’m from New Zealand and would like to contact you to do my tail lights for my R33 skyline. Will this possible? How can I get you
What's that fridge looking thing?
Did he say what type of led lights he used?
What would be a good place to get all the materials? Are those custom housings or 3d printed?
Plug n play kit?
I really want some custom led taillights for my wife's 2015 crv. No one makes them 🤷♂️
Can these even be done for the r34 ??
Hey Chris, I'm sure you've covered this but what resistor do you use on these led's? thanks!
Would be cool to learn how to do these as I wont be able to find anything in the UAE. But could try.
Man I need some help. I'm looking for 17 inch 20+ led tail brake turn light bar surface or flush mount not something that's gonna cost 800 bucks or more
How long did you bake them to separate the lens??
Too many splices. You should look into buying a very cheap tool for 40-pin IDE (out dated) ribbon cable plugs, and also install matching header sockets at each light fixture.